Choose a masonry or concrete drill bit by matching the material, hole size and drill chuck before comparing brands. Standard masonry bits cover many smaller holes in brick, block and light masonry. SDS systems are designed for rotary hammers and more demanding concrete work, while core-drilling systems create larger openings for pipes, cables and services.
National Tools carries a broad masonry and concrete drilling range, including more than 500 products across standard masonry, SDS-Plus, SDS-Max, hollow-core, chiselling and drill-bit-set pathways.
Browse standard masonry drill bits, SDS-Plus bits, SDS-Max bits, hollow-core drilling and masonry drill-bit sets.
The chuck or tool holder is the first compatibility check. A round-shank masonry bit belongs in a suitable keyed or keyless chuck. SDS-Plus and SDS-Max bits need their matching SDS tool holders. Do not force one shank type into another chuck or use an adaptor unless the machine and adaptor manufacturers permit that exact setup.
Also check the drill's stated diameter and core-drilling capacity. A bit may physically fit while still exceeding the machine's rated workload.
Start with the material. Brick and block can often be drilled with standard masonry tooling, although brittle material may chip if impact is too aggressive. Dense concrete generally benefits from a compatible rotary hammer and SDS bit. Reinforced concrete can stop or damage a standard masonry bit when it encounters steel; use a bit specifically designed for that application and follow the tool manufacturer's instructions.
Mark the required depth, keep the bit aligned and clear dust periodically so the flutes can remove debris. Excessive pressure creates heat and slows cutting. For large or deep holes, use the correct staged or core-drilling method instead of overloading a small drill.
Can an SDS bit be used in a normal drill chuck? Only with a suitable manufacturer-approved adaptor and within the drill's capacity. The safer choice is normally to use the bit with its intended SDS tool holder.
What is the difference between SDS-Plus and SDS-Max? They are different shank systems. SDS-Plus is commonly used for lighter and medium rotary-hammer work; SDS-Max is for larger compatible machines and heavier drilling or chiselling. They are not directly interchangeable.
Which bit should I use for wall plugs and anchors? Use the diameter and depth specified by the fixing manufacturer, then choose the appropriate standard masonry or SDS bit for the wall material and your drill.
Do I need a core drill for a large hole? Core tooling is usually the cleaner, more practical route for larger service openings, provided the machine, core, arbor or adaptor and pilot are compatible.
Showing 1–48 of 579 results
















































We use necessary technologies for the store to work. With your choice, we also use analytics and advertising measurement. You can accept or reject non-essential technologies.